3D Drain Holes Conversion

Convert holes into Caps to be used to more easily repair the model in post processing. 

Cap Gap

  • Sets the tolerance between the cap and the model
  • Can be set between 0.1mm and 10mm in 0.1mm increments. 

Hole Only

  • Only The model’s mesh will be solidified, converting any selected hollowing hole into new geometry.
  • Only the area occupied by both the the hollowing hole and the object will be converted. 

Cap Only

  • The Hollowing hole will be converted into a new object in the scene. 
  • Only the area occupied by both the the hollowing hole and the object will be used to create the cap.
  • The Cap will have a diameter smaller then the hollowing hole, set by the value  specified under Cap Gap.

Cap + Hole

  • The model’s mesh will be solidified, converting any selected hollowing hole into new geometry.
    • Only the area occupied by both the the hollowing hole and the object will be converted. 
  • Only the area occupied by both the the hollowing hole and the object will be used to create the cap.
  • The Cap will have a diameter smaller then the hollowing hole, set by the value  specified under Cap Gap.

Keep Cap in Place

  • ON – Any cap created will remain where it was generated.
  • OFF – The Cap will be moved to location  0x 0y 0x on the build plate upon generation.

Pro or Premium only

Last updated on

Tags: