Skip to content
Lychee Documentation
  • Home
  • About us
  • Contact us
Lychee Documentation
  • Home
  • About us
  • Contact us

J3D-Tech’s Guide to Resin Printing, Beginners - Advanced

  • Lychee Documentation
  • J3D-Tech’s Guide to Resin Printing, Beginners - Advanced
  • My recommended items for 3D printing
  • Resin Printer Maintenance

Resin Printer Maintenance

LCDTape

If you ever have to replace your LCD, screen protector or it’s just time to replace it.

Buy from Amazon
Back to Top

Super Lube 21010

Make sure you keep your rails & screw clean and lubed, you don’t need much.

Buy from Amazon
«Previous
Next»
Back to Top
Previous Article

Resin Printer Cleaning

Next Article

Printed Model Post Processing

  • Introduction
    • Good to know...
  • Printer Installation
    • Levelling the Bed
    • Resin Mixing and FEP Squeegee
    • VAT Clean after a failed print
  • Printer Calibration
    • Build Plate Calibration
    • Normal Layer Calibration
    • Burn-in-Layers / Bottom Layers Calibration
    • Two Stages Motion Control (TSMC) Calibration
    • Slice and Export Test Files
    • Prep your 3D Printer
    • Boxes of calibration
    • Calibrated resin profiles
  • Print Settings
    • Two Step Motion Control (TSMC)
    • Anti-aliasing
    • Rafts
    • Model Sizes
    • Model Orientation
    • Introduction to Supporting
    • Advanced Supporting
    • Hollowing
    • Printing on the Plate
    • The truth about 90% of Failures
  • Post-Processing
    • Video demo
    • Build Plate Removal
    • First Clean
    • 2nd Clean
    • 3rd Clean
    • Support Removal
    • 4th Clean
    • Final Dry
    • Final Cure
    • Can you Over Cure resin 3D prints?
  • Cleanup and Disposal
    • Trash
    • Cleaning your FEP
    • Emptying and Removing The Vat
    • Clean your LCD
  • Troubleshooting Print Failures
    • Layer Lines
    • Volcanoes
    • Just the supports
    • Split-Rafts
    • Flat rafts and/or Supports stop printing. 
    • Nothing on the Build Plate 
    • Half of the prints stuck to the Build Plate
  • Safety
    • Mandatory equipment
  • My recommended items for 3D printing
    • My Favorite Resin
    • Heating
    • Resin Printer Cleaning
    • Resin Printer Maintenance
    • Printed Model Post Processing
    • Consumables
    • My version of a Wash Station
    • Power
    • Focus
  • Ressources / Assets
    • Manufacturer's Resin Profiles
  • Thank You !
    • Thank You !
  • Home
  • About us
  • Contact us

Mango3D

©2025 Mango3d.io. All right reserved.